Catpro Troubleshooting - AMX Optima Instruction Manual

CatPro Troubleshooting

Note: If undesirable display conditions persist after trying the troubleshooting procedures below,
contact technical support (see page 38).
Problem: The image does not display or is dark and severely distorted.
Solution: Try adjusting the gain and peak on the RX Module.
Problem: The image on the destination monitor displays missing, extra, or flickering pixels.
Solution: Try decreasing the brightness setting on the source decive to allow the signal to
Optima Instruction Manual
This problem may occur because of abnormally high signal amlitues from the source video
equipment execceding the CatPro's typical RGB range of 0 mv to 700 mv.
propagate throughout the system without any clipping or other signal degradation. Typically,
brightness can be adjusted by opening the video card drivers on the source device/PC
(e.g., from the Control Panel settings, select Intel GMA Driver) and in the Color Correction
tab, adjust the brightness setting down. After adjusting the brightness of the source device,
slightly readjust the gain on the RX Module until the image is clear and sharp.
RGBHV+Stereo to CatPro I/O Boards (with RX Modules)
105