Apweb; Apgraphic Eq - AMX Precis DSP Instruction Manual

Controlling the System

APWeb

APWeb requires an external module. For installation directions, see the Quick Start Guide that ships with
the APWeb Module. For directions on executing and disconnecting switches using APWeb, see the APWeb
documentation on the AMX AutoPatch CD or at www.amx.com.

APGraphic EQ

The APGraphic EQ has a CrossBar (interface with crosspoints for switching) that can be used for ongoing
control after the system is set up and fine tuned.
For instructions on installing and opening APGraphic EQ software on a PC, see page 18.
APGraphic EQ has three views (windows) for adjusting and routing signals.
Note: APGraphic EQ has a drop down list with two virtual matrix choices, VM 0 (all) and VM 2 (audio);
either virtual matrix can be used since the Precis DSP has a single (stereo audio) virtual matrix.
Executing Switches Using the CrossBar
The crosspoint images in the CrossBar field represent the intersections of the input channels (buttons on
the left) and the output channels (buttons along the top). The channel names and CrossBar color can be
customized (see page 29).
The CrossBar below shows Input 1 routed to Outputs 1, 2, 3, and 6 and Input 8 routed to Outputs 7 and 8.
Tip: Hold the ALT key down and move the mouse across the desired crosspoints to select or deselect
consecutive crosspoints (do not hold down the mouse buttons).
To execute or disconnect switches with the CrossBar:
1. From the main interface, open the Options menu and select Show > CrossBar View.
2.
Click a crosspoint to execute a switch.
3.
The crosspoint changes to an active state and the switch is routed.
Or
Click an active crosspoint to disconnect a switch.
The crosspoint returns to its inactive state and the switch is disconnected.
Note: A switch can also be executed or disconnected by clicking the input and the output channel
buttons.
28
APGraphic EQ main interface – used for adjusting volume (page 22), tone (page 25), and
equalization bands and balance (page 24).
CrossBar view – opens from the Options menu for routing inputs to outputs (see below).
Input Gain view – during system setup, this view can be opened for adjusting input gain
(see page 23).
Place the cursor over a crosspoint to display the
input/output numbers for the crosspoint.
Precis DSP Instruction Manual