Intermec EasyCoder 501 E Installation & Operation Manual page 35

Chapter 5 Media Load
Cut-Off, cont.
10
Turn the printhead lift lever to "Print" posi-
12
Route the media through the cutter between the
two guide plates.
34
tion.
11
1.
Release the slack absorber (1). Adjust the
green edge guide so the media is guided with a
minimum of play (2).
13
Close the cutter while pulling at the end of the
media. Close the right-hand door.
Intermec EasyCoder 501 E – Installation & Operation Ed. 1
2.