Life Fitness Lifecycle LC9500 Service Manual page 82

Lifecycle Upright Bikes LC95, LC91, LC85, C9, C7, 95Ce, 95Ci, 93Ci, and 90C
How To... Remove Pedals, Crank Arms, and Shrouds - Continued
Special Service Tools: NONE
4. Remove three screws from the
left crank hub, and then remove
the left crank arm from the crank
shaft with pedal attached.
5. Remove the remaining three
frame screws from the upper
half of the left shroud, and then
remove the left shroud.
Note: If only the left shroud needs
removal, then remove the four lower
screws and one screw in the top
rear of the shroud from the right
shroud which secures the two
shroud halves together, and then
remove the remaining three frame
screws on the upper-side of the left
shroud. See illustration on previous
page.
6. Install shrouds in reverse order.
7. Torque the shroud screws 12-15
in lbs.
8. Torque crank hub screws 15-20 ft lbs. These screws can be reused up to 5 times before needing replacement.
Torque the pedals 10-15 ft lbs if removed.
Plug
4
Left Shroud
Shroud Screw (3)
to Frame
(12-15 in lbs)
Crank Hub
Screws(3)
(15-20 ft lbs)