Life Fitness Lifecycle LC9500 Service Manual page 111

Lifecycle Upright Bikes LC95, LC91, LC85, C9, C7, 95Ce, 95Ci, 93Ci, and 90C
How To... Remove the Telemetry Receiver and Telemetry Receiver Cable
(LC9500, 9100, 8500, and C7)
Special Service Tools: NONE
Telemetry Receiver
1. Remove four screws securing the top sensor cover.
2. Unplug the telemetry sensor from its connector.
3. Install new telemetry sensor in reverse order.
Telemetry Receiver Cable
Note: The telemetry cable is connected to a connector mounted in a
bracket. This bracket is mounted to the inside of the console post,
under the sensor cover. The other end of the cable is connected into
the back of the console display board. Proceed with the following
steps to properly replace this cable.
1. Remove the telemetry sensor as indicated above.
2. Remove the console display. See How To...Remove Display
Console and Accessory Tray.
3. Raise the console display just enough to access the telemetry
cable connector and disconnect it from the back of the console
board. Now tie a 3 ft piece of string around the end of this
connector. This will act as a fish line for pulling in the new cable.
4. Lower the bottom sensor cover on the console post to access the
bracket screws. Remove two screws in the back of console post, which secures the bracket which is located
inside the console post where the telemetry connector mounts and telemetry sensor plugs-in.
5. Pull out the bracket with attached telemetry connector and
cable from the console post just enough to disconnect the
telemetry cable leads from the connector on the bracket
6. Now gently pull out the telemetry cable until the string appears.
Remove the string from the old cable and attach it around the
new telemetry cable.
7. Before fishing the new cable through the console post,
reconnect the telemetry cable leads back into the connector on
the bracket. Now start pulling on the string until the new
telemetry cable appears through the console post. Reconnect
the connector at the other end of the cable to the back of the
console board.
8. Reattach the console display back on the console post.
9. Now go back and secure the bracket inside the console post with the two screws.
10. Plug-in the telemetry sensor back into its connector.
11. Secure the top cover to the bottom cover.
Connector
to Display
Board
33
Bracket
Telemetry
Screw
Connector
Inserts(2)
Telemetry
Cable
Sensor
Cover
(Top)
Telemetry
Sensor
Sensor
Cover
(Bottom)
Screws(2)