Page 1
Lifecycle Exercise Bike A S S E M B L Y I N S T R U C T I O N S...
Page 2
Congratulations... Life Fitness and welcome to the world of and the Lifecycle C7i / C9i exercise bike. The following Parts Identification Listing and the step-by-step installation procedures have been assembled to make the set-up of your exercise bike as quick and easy as possible.
Parts Listing prior to setting the cartons and shipping material aside. If any parts are missing, contact Life Fitness Customer Support Services at the number listed on the back page of this Installation Instruction Guide.
Page 5
CAUTION: Improper insertion of the seat pin may result in serious injury. Always make sure the pin is properly engaged in the seat post hole prior to using the Lifecycle exercise bike...
Page 6
Before proceeding, familiarize yourself with the parts of the Lifecycle exercise bike and make sure that you have received all the items described in the Parts List. Remove the STABILIZER BAR (#7) from the carton base. Use the empty CONSOLE CARTON to raise the rear of the LIFECYCLE exercise bike as shown.
Page 7
There is a large hole in the rear of the display console (#6) through which you can see a 10-pin connector and a 4-pin connector. These correspond to the matching connectors on the wire harness protruding from the top of the handlebar. Model C7i Only: Properly align the locking tabs of the 16-PIN CONNECTOR (16P) on the WIRE HARNESS with the 16-PIN CONNECTOR on the back of the DISPLAY CONSOLE, then...
Prior to your call, please be sure you have located and noted the The Model & Serial number information of your Life Fitness recumbent exercise bike is contained in a label located under the center of the front stabilizer bar (See previous page).