Single Board Computer - Life Fitness Lifecycle LC9500 Service Manual

Lifecycle Upright Bikes LC95, LC91, LC85, C9, C7, 95Ce, 95Ci, 93Ci, and 90C
How To... Replace the Single Board Computer
Special Service Tools Required: NONE
Single Board
Computer
Single Board
Computer
Mounting
Screws (7)
Polar Cable
CAUTION! BEFORE REPLACING CIRCUIT BOARD(S), GROUND YOURSELF TO EARTH GROUND
USING AN ANTI-STATIC GROUND STRAP.
1. Remove console from unit refer to Display Console and Accessory Tray Removal.
2. Remove seven screws from the Back Cover.
3. Disconnect all of the cables from the Single Board Computer.
4. Remove seven screws securing the Single Board Computer to the back of the LCD Touch Screen. The
Single Board Computer remains engaged into a 24-Pin Connector Receptacle, which is located between
two Connector Pins on the Interface Board. Carefully wiggle the Single Board Computer up and out of the
Interface Board Connector Receptacle and Connector Pins.
5. Install Board in reverse order. Been careful on connecting the single board computer to the machine
interface board.
24-Pin Connector
Receptacle
Connector
Connector
Pin
Pin
24-Pin
Connector
40
5-Pin Touch Screen
Communication
Ribbon Cable
41-Pin LCD
Communication
Ribbon Cable