Installation - John Lewis JLBIOS614 User Manual

Installation

Warning! Refer to the Safety
chapters.
Important! The built-in unit must meet
the stability requirements of DIN 68930.
The oven is designed to be connected to 230 -
240V ~ (50Hz) electricity supply.
The oven has an easily accessible terminal block
which is marked as follows:
Letter L - Live terminal
Connection via
Cooker Control Circuit
It is necessary that you install a double pole
switch between the oven and the electricity
supply (mains), with a minimum gap of 3 mm
between the switch contacts and of a type
suitable for the required load in compliance with
the current regulations.
The switch must not break the yellow and green
earth cable at any point.
Important! After installation and
connecting, the cable must be placed so
that it cannot at any point reach a
temperature of more than 50°C above
the ambient temperature.
Before the oven is connected, check that
the main fuse and the domestic
installation can support the load; and
that the power supply is properly
earthed.
Oven user manual
Min. size Cable/flex
2,5 mm²
Letter N - Neutral terminal
- Earth terminal
Caution! This oven must be
earthed!
The cable used to connect the oven to the
electrical supply must comply to the
specifications given below.
For UK use only
Cable/flex type
PVC / PVC twin and
earth
The manufacturer declines any
responsibility should these safety
measures not be carried out.
Fuse
min: 15 A
max: 20 A
51