Cleaning The Oven Door; Installing The Door And The Glass Panels - John Lewis JLBIOS614 User Manual

3. Remove and clean the metal frame and the
seal.
4. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
5. Install the metal frame and the seal. Tighten
the screws.
6. Install the left shelf support.

Cleaning the oven door

You can remove the oven door and the internal
glass panels to clean it. The number of glass
panels is different for different models.
Caution! Be careful when you
remove the door from the
appliance. The door is heavy.
Removing the door and the glass panels
1. Open the door fully.
2. Fully press the clamping levers (A) on the
two door hinges.
A
3. Close the oven door to the first opening
position (approximately 70° angle).
4. Hold the door with one hand on each side
and pull it away from the appliance at an up
angle.
Caution! Put the door with the
outer side down on a soft cloth
on a stable surface. This is to
prevent scratches.
Oven user manual
5. Hold the door trim (B) on the top edge of
the door at the two sides and push inwards
to release the clip seal.
B
6. Pull the door trim to the front to remove it.
7. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
8. Clean the glass panel with water and soap.
A
Dry the glass panel carefully.

Installing the door and the glass panels

When the cleaning is completed, install the glass
panels and the oven door. Do the above steps
in the opposite sequence. Install the smaller
panel first, then the larger.
49