Using The Accessories; Core Temperature Sensor - John Lewis JLBIOS614 User Manual

Using the accessories

Warning! Refer to the Safety
chapters.

Core temperature sensor

The core temperature sensor measures the
core temperature of the meat. When the meat
is at the set temperature, the appliance
deactivates.
There are two temperatures to set:
• The oven temperature: refer to the table for
roasting.
• The core temperature: refer to the table for
the core temperature sensor.
Important! Only use the core
temperature sensor supplied or the
correct replacement parts.
1. Activate the appliance.
2. Put the tip of the core temperature sensor
(with on the handle) into the centre of
the meat.
22
3. Put the plug of the core temperature sensor
into the socket at the front of the appliance.
The display shows
core temperature. The temperature is 60
°C for the first operation, and the last set
value for each subsequent operation.
4.
Touch or
temperature.
5.
Touch or the settings save
automatically after 5 seconds.
Useful information:
You can set the core temperature only
when flashes. If
but does not flash before you set the core
temperature, touch the field °C and
to set a new value.
6. Set the oven function and, if necessary, the
oven temperature. The display shows the
current core temperature and the
temperature bar, which shows the relation
between the set oven temperature and the
current oven temperature.
Useful information:
The core temperature sensor must stay in
the meat and in the socket during the
cooking.
While the appliance calculates the
approximate duration time, the value of the
Count Up Timer function shows in the
Timer / residual heat display. When the
first calculation ends, the Timer / residual
heat display shows - and then the
approximate duration of the cooking. The
appliance continues to calculate the
duration during the cooking. The display
updates at intervals with the new duration
value.
7. When the meat is at the set core
temperature, the core temperature and
flash. An acoustic signal sounds for two
and the default set
to set the core
is in the display
Oven user manual
or