Setting The Set+Go; Setting The Minute Minder; Setting The Time Delay Function - John Lewis JLBIOS614 User Manual

4. When the set time ends, an acoustic signal
sounds for two minutes.
symbol and the time setting flash in the
display. The appliance deactivates.
5. Touch a sensor field or open the oven door
to stop the acoustic signal.
6. Deactivate the appliance.
Check result (selected models only)
If you set the END or DURATION function,
two minutes before the end of cooking an
acoustic signal sounds and the lamp activates.
The appliance goes to the setting of the END or
DURATION function. During these two
minutes you can examine the results of the
cooking, and, if necessary, add the END or
DURATION time.

Setting the SET+GO

1. Set an oven function (or programme) and
temperature (refer to "Setting the oven
function" and "Changing the temperature").
2. Set the DURATION (refer to "Setting the
DURATION").
3. Touch the field Time functions again and
again until flashes in the display.
4.
Touch to set the SET+GO function.
The display shows
indicator. This indicator shows which clock
function is activated.
5. Touch a sensor field (apart from ON /
OFF) to start the SET+GO function.
You can use the SET+GO function
only when the DURATION is set.

Setting the MINUTE MINDER

Use the MINUTE MINDER to set a countdown
(maximum 2 h 30 min). This function has no
effect on the operation of the oven. You can set
18
and with an
the MINUTE MINDER at any time and also
when the appliance is off.
1.
Touch the field Minute timer.
"00" flash in the display.
2.
Use or to set the MINUTE
MINDER. First you set the seconds, then
the minutes and the hours.
3.
Touch or the MINUTE MINDER starts
automatically after five seconds.
4. When the set time ends, an acoustic signal
sounds for two minutes and 00:00 and
flash in the display.
5. Touch a sensor field or open the oven door
to stop the acoustic signal.

Setting the Time delay function

The DURATION
be used at the same time, if the oven is to be
activated and deactivated automatically later. In
this case, first set the DURATION
the END function (refer to "Setting the
DURATION" and "Setting the END" ).
When the Time delay function is activated, the
display shows a static symbol of the oven
function, with a dot and
which clock function is on in the Clock /
residual heat display.
and
and END functions can
and then
. The dot shows
Oven user manual