Using Auxiliary W O O Dfacing On The Unifence; Constructing A Push Stick - Delta Unifence 36-905 Manual

USING AUXILIARY W O O D
FACING ON THE UNIFENCE
It is necessary when performing special operations such
as when using the moulding cutterhead to add wood fac-
ing (A) Fig. 68, to one side of the rip fence as shown. The
wood facing is attached to the fence with wood screws
through holes drilled in the fence. 3/4 inch stock is suit-
able for most work although an occasional job may
require one inch facing.
When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily
be made from scrap material by following the pattern shown in Fig. 69 (not shown to scale).
C U T OFF H E R E TO
P U S H 1/4 W O O D
C U T OFF H E R E TO
P U S H 1/2 W O O D
1/2 S Q U A R E S

CONSTRUCTING A PUSH STICK

N O T C H TO HELP
PREVENT H A N D
F R O M SLIPPING
A
P U S H STICK
M A K E F R O M 1/2 O R 3/4
W O O D O R THICKNESS
LESS THAN WIDTH OF
M ATL . TO B E C U T
Fig. 69
19
Fig. 68