Adjusting Fence Parallel To Miter Gage Slots; Adjusting Fence 90 Degrees To Ta B L E; Adjusting Clamping Action Of Fence Locking Handle - Delta Unifence 36-905 Manual

ADJUSTING FENCE
PARALLEL TO
MITER GAGE SLOTS
The fence (A) Fig. 59, should be adjusted so it is pa r a l l e l
to miter gage slots ( B ) . To check and adjust, move the
fence (A) until the bottom front edge of the fence is in line
with the edge of the miter gage slot as shown, and push
down on fence clamping lever (C). Check to see if the
fence is parallel to the miter gage slot the entire length of
t h e table. If the rear of the fence must be moved, slightly
tighten or loosen one of the adjustment plugs (D) or (E)
Fig. 59, using the arbor wrench or 7/8 wrench, until the
fence is pa r a l l e l w i t h t h e m i t e r g a g e s l o t . IMPORTA N T:
DO NOT OVERTIGHTEN ADJUSTMENT PLUGS (D)
AND (E) FIG. 59. VERY LITTLE MOVEMENT OF THESE
ADJUSTMENT PLUGS IS NECESSARY WHEN AD-
JUSTING THE FENCE PARALLEL WITH THE MITER
GAGE SLOT.
ADJUSTING FENCE
90 DEGREES TO TA B L E
The fence must be adjusted so that the face of fence (A)
Fig. 60, is 90 degrees to the ta b l e . To check if the fence
is 90 degrees to the table, place a square (B) on the table
with one end of the square against the fence, as shown.
If an adjustment is necessary, tighten or loosen one of
two screws (C) or (D) using the wrench supplied, until the
fence is 90 degrees to the ta b l e . IMPORTA N T: VERY
LITTLE MOVEMENT OF THESE SCREWS (C) AND (D)
IS NECESSARY TO MAKE THIS ADJUSTMENT.
ADJUSTING CLAMPING
ACTION OF FENCE
LOCKING HANDLE
When the fence locking handle (A) is pushed to the down
position, as shown in Fig. 61, the fence body (B) should
be completely clamped to the guide rail. If the fence body
(B) is not completey clamped to the guide rail when the
handle (A) is in the position shown in Fig. 61, lift up on
locking handle (A) Fig. 62, and slightly tighten two adjust-
ment plugs (C) using arbor wrench or 7/8
Adjustment plugs (C) should be tightened an equal
amount. Check to see if the fence body (B) is completely
fastened to the rail by pushing down on locking lever (A).
Adjust further if necessary. IMPORTA N T: AFTER AD-
JUSTING THE CLAMPING ACTION OF THE FENCE
LOCKING HANDLE, CHECK TO SEE IF THE FENCE
IS PARALLEL TO THE MITER GAGE SLOT A N D
ADJUST IF NECESSARY.
B
D
wrench.
C
17
A
C
E
Fig. 59
Fig. 60
A
B
Fig. 61
A
B
Fig. 62
C