Delta Unifence 36-905 Manual page 9

1 0 . Fold the top portion of the template toward you in the
line marked top of guide rail
11 . Position the template on the guide rail, as shown in
Fig. 25, with the printed side of the template against the
guide rail and the fold in the template along the top of the
rail. Position the template so that edge (G) which was cut
i n STEP 9 is aligned with the 0 mark on the scale, as
shown. Tape the template in place on the guide rail. Hole
(H) Fig. 25, indicates the hole that was drilled in the table
i n STEP 8D and is the location of the new hole to be
d r i l l e d i n t h e g u i d e r a i l .
1 2 . Center punch the location of the new hole(s) (H)
Fig. 26, to be drilled in the guide rail, as shown. Remove
the template and drill the new 7/16 diameter hole(s) in
the back of the guide rail.
FOR ALL TABLE SAW S
IMPORTA N T: If the mounting holes in the front of the
t able saw are threaded, the threads must be drilled out to
7/16 inch thru holes.
1 3 . The guide rail (N) Fig. 27, has end caps, one of
which is shown at (W), inserted into each end of the rail.
Remove the left end cap (W) Fig. 28, by inserting a flat
headed screwdriver (X) into the channel in front of the
guide rail and press outward against the inside of the end
cap (W) as shown. The end cap (W) will pop out. NOTE:
DO NOT ATTEMPT TO REMOVE THE END CAP B Y
FORCING THE SCREWDRIVER BETWEEN THE END
C A P AND THE END OF THE RAIL. THIS WILL D A M-
AGE BOTH THE CAP AND THE RAIL.
Fig. 27
(F), as shown in Fig. 24.
A
H
G
9
F
Fig. 24
Fig. 25
H
Fig. 26
B
A
Fig. 28