Delta Unifence 36-905 Manual page 11

SWITCH MOUNTING F O R D E LTA SERIES 2000
10 C O N T R A C TOR S S AW S EQUIPPED WITH
M O D E L NO. 36-905 30
2 0 . The ON/OFF switch (X) Fig. 33, for the Delta Series
2000 10 Contractor s Saw is mounted to the left exten-
sion wing (V) as shown.
2 1 . Fasten the ON/OFF switch (X) Figs. 33 and 34, to
guide r a i l ( N ) using 1/4-20 x 1 long screw and flat wash-
er (S). Do not completely tighten screw at this time.
2 2 . Using a square (O) Fig. 35, adjust the extension
wing ( V ) pa r a l l e l t o s a w table (Y), then tighten screw (S)
F i g . 3 4 .
N
Fig. 34
F O R ALL TA B L E S AW S
2 3 . Fasten the guide rail (N) Fig. 36, to extension wing
(V) by threading 1/4-20 x 5/8 inch-long screw (S) Fig. 36,
with flat washer through slotted hole in the front of exten-
sion wing (V), and into threaded hole in guide rail (N) as
shown.
S
X
C A PACITY UNIFENCE
11
V
N
X
Fig. 33
Y
V
O
Fig. 35
N
V
S
Fig. 36