Assemblingr E A R Extension W I N G S U P P O R T B A R - Delta Unifence 36-905 Manual

2 4 . Move front table support (R) Fig. 37, until it conta c ts
the back of guide rail (N) and fasten with 1/4-20 x 5/8
inch-long screw and flat washer (S).
2 5 . Tighten two screws (T) Fig. 38, that fasten table to
f r o n t table support (R).
2 6 . Replace end cap (W) Fig. 39, that was removed in
STEP 13.
F O R ALL D ELTA S AW S EQUIPPED WITH
STA M P E D STEEL EXTENSION WINGS
ASSEMBLING
R E A R EXTENSION W I N G
S U P P O R T B A R
1 . Assemble rear extension wing support bar (A)
F i g . 4 0 , to the saw table and extension wing, using three
3/8-16 x 1 long hex head screws, flat washers, and hex
n u ts ( B) .
N
R
S
R
T
B
12
Fig. 37
T
Fig. 38
Fig. 39
A
B
Fig. 40