Table of Contents
Advertisement
*
Select the Patch you want retrieve, using the BANK DOWNIUP key and the
PATCH
1
to 4 key. In this case, the sound of the effect can be monitored.
0
To store the Patch in memory
-
press the
STORE
key. This operation puts the 9000
in
the Standby status. Then, select the
Bank
number with which the Patch is to be stored and
the Patch number. Press the STORE key again (if you want to stop the operation, use the
EDIT/C ANCEL key).
.To edit the Patch
-
press the CANCEL key. The
9000
goes into the Play mode with the
Patch unchanged. Then, put the
9000
in the Edit mode, using the EDITICANCEL key.
Patch Setting to the factory-set Status (Initialize)
Initialization is a special function which sets the Patches and other settings of the 9000 in the
factory-set status. Note that when you carry out the initializing function, all the Patches
stored in memory will be deleted.
In the Play mode, hold down the STORE key for about one second or more
while holding down the EDlTlCANCEL
key.
The contents of the display changes as shown in the lollowing figure.
Displayed Items in the Initializing Standby Status
0
To initialize
all the Patches
-
press the STORE key. "AL" on the display starts flashing.
Then, press the STORE key again. (This operation can be canceled by pressing the
EDIT/C ANCEL key).
0
To stop the initializing operation in a half
way
-
press EDIT/CANCEL key. This
operation puts the 9000 back in the Play mode.
% W :
When the initializing function is carried out, calibration settings of the master volume and the
tuning will
be
set also back in the factory-set status.
Advertisement
Table of Contents
