Table of Contents
Advertisement
This parameter determines the amount of boost for the frequency
to be set with the following
FREQP
parameter.
(2) FREQ (Frequency): 0
to
50
T h i s
parameter determines the center frequency to be boosted
(3) PEAK (Peak): 0 to 10
This
parameter determines the range of the sound
to be
boosted. The higher the value is, the
narrower the range is set.
0 FLANGE (Flanger)
This Effect Type adds an effect sound which is delayed by some 10 ms
to
the direct sound,
and changes the delay time periodically. This effect obtains an intense sound. When
combined with distortion, a swirling flanger sound called "jet sound" is obtained.
Parameter]
(1)DEPT (Depth): 0
to
10
This parameter determines the depth of the flanger effect.
(2) RATE: 0 to 50
This parameter determines the speed of modulation to the flanger effect.
(3)
PEAK (Peak):
0 t o 10
This parameter determines the amount of feedback from the effect output to the input.
Increasing this value pronounces the modulation effect more and gives a more intense effect
to the sound.
CHORS1 (Chorus
1)
This Effect
Type
adds the effect sound whose pitch is modulated periodically, to the direct
sound. This gives a mono chorus effect which has spatially wide feeling,
to
the sound. The
principle of this effect is similar to flanger. However,
this
effect does not have parameters for
feedback.
[Parameter]
(1)DEPT (Depth): 0 t o 10
This parameter determines the depth of the tone change.
(2)RATE: 0 to 50
This parameter determines the speed of the tone change.
(3)
MM
(Effect mix):
0
to
10
This parameter determines the mix amount
of
the effect sound with the direct sound. Setting
to
0
outputs only the direct sound while setting to
10
outputs a maximum of the effect sound.
**
% W :
To obtain a comfortable vibration, adjust
the
depth according to the change of the rate.
Advertisement
Table of Contents
