Table of Contents
Advertisement
Storing the Edited Patch
The edited parameter in the Edit mode will
be
deleted when another Patch is selected if it has
not been stored in memory. Store the Patch you prefer when you have created that Patch.
a
When setting of each parameter has been completed in the Edit mode, press
the STORE key.
T h i s
operation puts the 9000 in the store Standby status, and the Bank number and the Patch
number
S
tart flashing.
Using the BANK DOWNIUP key and the PATCH
1
to
4
key, specify the Bank
number in which the Patch i s to be stored and the Patch number.
If the
Bank
number is not specified, the edited Patch will be stored
in
the Bank currently
being selected.
Press the STORE key. This operation stores the Patch in memory, and the
9000 goes back in the Play mode. If you press the EDITICANCEL key before
pressing the STORE key, the 9000 stops the store operation and goes into
the Play mode.
% *
Even when the
9000
goes back into the Play mode, the edited Patch remains unchanged until
you have called another Patch.
Factory-set Patches
The 9000 has the original Patch data which is the same as the factory-set Patch data, in
the
ROM (Read Only Memory) of the 9000. If you have accidentally deleted or changed the
factory-set Patches, the factory-set Patch data can be retrieved and stored from the
ROM.
In the Play mode, press the AMWLINE for one second or more key while
holding down the EDITICANCEL key.
The displayed contents change as shown in the following figure. This indicates that the
preset Patches are ready to be retrieved
BANK PATCH
Displayed items in Preset Recall Standby Status
Advertisement
Table of Contents
