Adjustment options
The adjustment of the angle of the leg-rests can be done as follows:
•
Push the handle (B) forward.
•
The leg rest goes upwards.
•
Release the handle in the desired position.
If the leg support is too high, do the following:
•
Push the handle (B) forward.
Now the gas spring is unlocked.
•
Push the leg-rest with a light pressure from your leg in the desired position and hold it
in that position.
•
Release the handle.
In this position the leg-rest is fixed and you can allow your leg to rest.
XXXXXX-010504050.nl.doc
5.6
Adjusting the footplate
See fig. 010506000.
The following can be adjusted on the
footplate:
A
The angle.
B
The depth.
The footplate can also be folded up to ease
transfer and positioning.
XXXXXX-010506000.nl.doc
5.6.1
Adjusting the angle of the
footplate
See fig. 010506010.
The angle of the footplate can be adjusted
with respect to the lower leg in steps of 5°.
The angle of the footplate should be adjusted
as follows:
•
Loosen locking nut (A) with a large
screwdriver.
•
Then loosen the Allen bolt (B) on the inside
of the footplate (C), with an Allen key with a
key width of 6 mm, so far that the teeth of
the hinge come completely free. Now the
footplate can be freely adjusted.
•
Adjust the desired angle of the footplate
and push the hinge manually together
again.
•
Tighten the Allen bolt securely.
38
B
B
C
A
XXXXXX-010506010.nl.doc
A
010506000
010506010