Adjusting The Depth Of The Leg-Rest; Comfort Leg-Rest With Gas-Spring Angle Adjustment - Handicare Ibis 24 User Manual

5.5.3 Adjusting the depth of the
leg-rest
See fig. 010504030.
Depending on the length of the upper legs,
the leg-rests can be adjusted in terms of
depth.
The adjustment of the depth of the leg-rests
should be done as follows:
•
Loosen the Allen bolt (A) a few turns with
an Allen key with a key width of
6 mm.
•
Adjust the desired depth by sliding the
entire suspension bracket forward or
backward.
•
Tighten the Allen bolt securely again.
If the leg-rests are set too far backward (too close to the chair) it is
possible that the swivel castors touch the leg-rests when driving
backward or maneuvering. If this is the case, the leg-rests must be
brought forward a bit: there must be at least 1 cm (3/8") cm between
wheel and leg-rest.
If the leg-rests are set too far forward, it is possible that the
suspension bracket of the leg-rest comes out from under the seat
and pushes into the knees uncomfortably.
If this is the case, the seat should be adjusted forward.
See 'Position of the seat cushion'.
EBAXXX-010504030.nl.doc
5.5.4 Comfort leg-rest with gas-
spring angle adjustment
See fig. 010504050.
The comfort leg-rests are angle adjustable (A)
independently of each other. There is a gas
spring on each leg-rest that delivers enough
force to allow the leg-rest to go up easily.
If you wish to adjust the angle of the leg-rest,
move your leg upward so that the leg-rest can
move upward freely.
Adjustment options
A
010504030
B
A
010504050
37