Honeywell HMAX082 Owner's Operation Manual page 71

8.3.3 Programming Auto-Sequences, Continued
Insert – Using the up and down arrow keys, position the cursor on the line below
where you want to insert a camera (or left click over the row you wish to insert on to
place the blinking cursor in a textbox in that row) and click the Insert button. For
example to insert a camera between stage 3 and stage 4, position the cursor on
stage 4 and click on Insert.
Remove – Position the cursor on the camera you want to delete and click on the
Remove button. The cameras below the removed camera all move up one stage.
Send – After editing/programming the auto sequence, click on the Send button to
transmit the configuration to the MaxCom Gold.
Receive – To transmit the current configuration for a monitor from a MaxCom Gold
to the PC configuration utility, click on the receive button.
Reload – To return the screen to the default configuration or to the configuration
prior to any changes made in this editing session, press the Reload button.
Save – To save the configuration, click on the Save button.
Vertical Scroll Bar – To view more stages, click on the arrows on the scroll bar.
One click on an arrow moves the screen up one stage at a time. Holding down the
left mouse button while pointing to an up or down arrow, continuously scrolls
through the stages until the mouse button is released or the end of the available
stages (1-128) is reached. Alternatively, you can left click and drag the button in the
scroll bar to make larger steps.
Up/Down Arrows (on side of window) – To move a camera up or down within the
programmed sequence, position the cursor on the camera you want to move and
click on the up or down arrow until the camera is in the desired location. Each click
moves the camera one line (stage) up or down.
3. Enter data in the fields as desired. To change the displayed configuration, overwrite
the entries in the fields by typing the desired numbers. The fields in the auto-
sequence are as follows.
Stage – This field is not user programmable. This is the order in which the cameras
are sequenced on the monitor.
Camera – This is the camera number (1-8 or 1-16 depending on your configuration)
where the camera is connected to the MaxCom Gold.
Title – This field is not user programmable from this menu. If a title has been
programmed for the camera in the camera setup menu, the title is displayed.
Dwell – The dwell time is the amount of time (0-100 seconds) the user wants the
MaxCom Gold to display the video from the camera before switching to the next
camera in the sequence.
Rev. 1 59 900.0560
18-July-2005