Honeywell HMAX082 Owner's Operation Manual page 103

8.4.5 Tours, Continued
Vertical Scroll Bar – To view more stages, click on the arrows on the scroll bar.
One click on an arrow moves the screen up one stage at a time. Holding down the
left mouse button while pointing to an up or down arrow, continuously scrolls
through the stages until the mouse button is released or the end of the available
stages (1-128) is reached. Dragging the button in the scroll bar will enable larger
steps.
Up/Down Arrows (on side of window) – To move a preset up or down within the
programmed tour, position the cursor on the preset you want to move and click on
the up or down arrow until the preset is in the desired stage location. Each click
moves the preset one line up or down.
3. Enter data in the fields as desired. To change the displayed configuration, overwrite
the entries in the fields by typing the desired numbers. The fields in the auto-
sequence are as follows.
Stage – This field is not user programmable. This is the order in which the camera
sequences through the presets.
Preset – This is the preset number (0-127).
Title – This field is not user programmable from this menu. If a title has been
programmed for the preset in the preset title menu, the title is displayed.
Speed – The default speed for the RapidDome to travel to a preset is 30°/second.
The selectable range of speeds is from 1 (1°/second) up to 100 (100°/second).
Entering a 0 selects the maximum travel speed.
Dwell – The dwell time is the amount of time (1-254 seconds) the user wants the
MaxCom Gold to display the current stage (preset) before going to the next
programmed stage (preset).
To move between the fields, use the tab key to move forward one field, use the
shift+tab keys simultaneously to move backward one field. Use the up and down
arrow keys on the PC keyboard to move up or down one line. A field can also be
selected by pointing to the field and clicking the left mouse button.
4. Click on the Save button to save any changes to the configuration.
5. Click on the Send button to transmit the tour to the MaxCom Gold. Note: This step
can also be done after all programming is complete using the Send Receive Centre
utility.
6. Select another tour for the same camera, select another camera, or close the menu
by clicking on the X in the upper right corner.
Rev. 1 91 900.0560
18-July-2005