Tours - Honeywell HMAX082 Owner's Operation Manual

7.1.3 Tours

A tour is a series of presets stored in memory that can be started by an operator causing
the RapidDome to travel to the defined presets automatically. Up to four (4) tours
(numbered 1 – 4) can be defined for each RapidDome.
a. From the camera menu, press 3 to access
the tour menu.
b. Select the camera by pressing the
number buttons that correspond to the
camera (1-16) then press the camera
button.
c. Select the tour number by pressing the
number buttons that correspond to the
tour (1-4), then press the aux button to
edit.
d. If an "END OF TOUR" is present and you want the tour to extend past the current
ending, press the aux button to clear the current end (whilst the cursor is on that
step).
e. Using the joystick (up, down, left or right), position the highlight on the desired field
to be changed, then enter the desired setting in the field.
The preset field range is 0-127.
The dwell range is 1-254 seconds.
The speed range is 1 (1°) to 100 (100°)/seconds.
Note: The down arrow to the right of the last step shown means there are more
lines below those displayed. If an operator moves down, an up arrow will be
displayed to the right of the first step to show there are more lines above those
displayed.
f. After you have programmed the desired steps in the tour, press aux to define the
end of the tour whilst on the next step after the last step in the tour.
g. Press lock to end programming and save the tour.
h. Program another tour or press lock to end programming tours and return to the
camera menu.
Rev. 1
CAMERA 01:LAB
STEP
001
002
003
004
23
TOUR SETTINGS
TOUR 1
PRESET DWELL SPEED
001:001 060 030
002:002 060 030
003:003 060 030
004:004 060 030
AUX TO SET END OF TOUR
LOCK TO END
18-July-2005
900.0560