Remote Reset - Honeywell HMAX082 Owner's Operation Manual

7.1.6.1 Defining a Sector Zone, Continued
Note: The camera should be panned in the clockwise direction, as viewed from the
Note:

7.1.7 Remote Reset

The remote reset enables you to reset a RapidDome from the MaxCom keyboard, i.e.
you can reset the camera without having to physically unplug it, or turn the power off
then on again for a particular camera.
Note: You will not be allowed to choose a different reset option after performing a reset
or leave the menu for approximately 10 seconds.
The remote reset feature is accessed from the camera menu.
From the camera menu, press 7.
There are three reset modes.
1. Power-Up Reset
The power-up reset allows you to reset the
RapidDome receiver and camera without the
loss of any programmed options, i.e. preset,
tours, etc. Once the camera has reinitialized
after a power-up reset, it returns to its previous
pan and tilt positions, zoom, iris, and focus
settings prior to the power-up reset being
executed.
Rev. 1
monitor, and in a direction away from the left edge. If the camera is moved in an
anti-clockwise direction, towards the left end, then you will create a big Sector
Zone.
Each of the sixteen Sector Zones has a priority. Sector Zone 1 has the highest
priority and Sector Zone 16 has the lowest priority. If any of the Sector Zones
overlap, the higher priority Sector Zone is displayed.
Figure 2. Defining A Sector Zone
29
REMOTE RESET MENU
1 POWER-UP RESET
2 CAMERA RESET
3 FACTORY RESET
SELECT OPTION
LOCK TO EXIT
18-July-2005
900.0560