Creating A Motion Area; Removing A Motion Area - Honeywell FUSION III DVR User Manual

Creating a Motion Area

Removing a Motion Area

________________________________________________________________________________________________________
Document 900.0803 Rev 8b
09/09
Tip Create up to 15 motion detection areas.
Click the Motion tab in Setup.
1.
2. Select a camera from the Select Camera list.
Select the Detect Detail Motion Area check box.
3.
4. Click Clear Motion Area.
5. Click Advanced Motion Area Setup.
Click a Motion Detection Area shape
6.
button.
7. Drag the mouse over the camera
image.
Tip To create a polygon shape,
click the mouse at each point
and double-click to close the
shape.
8. Click OK.
Move the sliders to adjust motion
9.
sensitivity and the noise filter.
10. Define the pre-alarm and post-alarm
recording time for a motion event.
Pre Alarm – 0 > 50 Seconds [The number of seconds the DVR records before motion
is detected]
Post Alarm (MOTION) – 0 > 50 Seconds [The number of seconds the DVR records
after motion is detected]
To remove all motion areas, click
Fusion III DVR User Guide
.
49