Configuring The Client Pc - Honeywell FUSION III DVR User Manual

Configuring the Client PC

________________________________________________________________________________________________________
Document 900.0803 Rev 8b
09/09
All configurations take place in the Alarm Monitor Window on the client PC. For
descriptions and locations of the buttons and features of the Alarm Monitor Window,
refer to the Alarm Monitor Window section later in this chapter.
1. Open the Alarm Monitor Window on the Client PC. Start >Programs > Fusion >
Alarm Monitor > Alarm Monitor.
2. Click New in the DVR List and enter the site code, site name, and IP Address of
the DVR in the Site Edit window. Click Save.
The site code can be found under the Information tab in the Setup Menu.
Note
Click the Tools Menu and select Setup.
3.
4. Confirm that the Listen Port in the Configuration Window is set to the same
number as the Emergency Port in Communication Settings on the DVR. If the
numbers are different adjust the Listen Port on the client PC to match the DVR.
Click Enter.
5.
6. Reboot the client PC.
Fusion III DVR User Guide
137