MP login:
NOTE: To switch between the iLO MP card and EFI console with iLO MP firmware E.02.20 or
higher, do the following:
■
If you are at the EFI console, press
■
If you are at the iLO MP command prompt, run the
mode.
2. Log in. The login options depend on your iLO MP firmware revision:
❏
iLO MP firmware E.02.10: there are no default iLO MP users. If you have not yet
created iLO MP users, press
❏
iLO MP firmware E.02.20 or higher: two default users exist:
◆
Administrator: login
◆
Operator: login
3. If you have not yet created iLO MP users, enter a default ID and password at the login and
password prompts and press
HP Management Processor
Firmware Revision E.02.11 Feb 14 2003,9:38:32
(c) Copyright Hewlett-Packard Company 1999-2001. All Rights Reserved
MP login:
MP password:
To ensure server security, HP recommends that the system administrator do one of the following:
■
Disable all remote access to the iLO MP including telnet, web, and remote modem
access using the
❏
iLO MP firmware E.02.10: Add a user with a unique password on servers
❏
iLO MP firmware E.02.20 or higher: Add a user with a unique password on servers and
delete the default users
Depending on your iLO MP firmware revision, either the command prompt or the menu displays.
❏
iLO MP firmware E.02.10: the iLO MP command mode prompt displays:
HP Management Processor
Firmware Revision E.02.10 Oct 1 2002,10:28:32
(c) Copyright Hewlett-Packard Company 1999-2002.
All Rights Reserved.
System Name: fstl3a
******************************************************************
MP users are currently configured and remote access is enabled.
Disable all types of remote access (see EL and ER commands)
************************************************************
MP Host Name: fstl3a
MP>
❏
iLO MP firmware E.02.20 or higher, the main menu displays:
Hewlett-Packard Management Processor
HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
-
Ctrl
B
Enter
at the login and password prompts for initial access.
Admin
, password
Oper
, password
Enter
for initial access.
SA
command, or use the
MP ACCESS IS NOT SECURE
Set up a user with a password (see SO command)
to access the iLO MP login screen.
CO
command to enter EFI console
Admin
Oper
UC
command to configure iLO MP users:
OR
System Configuration
47