HP Integrity rx2600 Operation And Maintenance Manual page 45

❏
Subnet, Gateway
❏
Web Console Port Number
❏
LAN hardware configuration (optional)
The Link State controls the speed at which the iLO MP card communicates with the
network.
◆ Select auto-negotiate to enable the server to make the fastest possible connection.
The iLO MP card also negotiates to half or full duplex. This is the default,
recommended in most cases.
◆
Select 10BaseT to force the iLO MP card to operate at the slower 10BaseT speed if
necessary for your network configuration. For example, if your network contains
both 10BaseT and 100BaseT connections, and you want the server to communicate
with the other 10BaseT connections, you must force it to operate at the slower speed.
NOTE: If you force the iLO MP card to operate at 10BaseT speed, it also operates at half duplex.
Make sure that your switch or hub is also in half duplex mode.
You can do the following in all options:
❏
To change the setting, enter the appropriate information and press
❏
To confirm your selections, enter
3. To reset the iLO MP card, run the
server iLO MP firmware revision.
❏
iLO MP firmware E.02.10:
xd
Non destructive tests:
1. Parameters checksum
2. I2C access (get Power Monitor status)
3. LAN access (PING)
4. Modem selftests
5. Secondary I2C access (get System status)
Type R to reset the MP or [Q] to quit the diagnostic menu.
-> Choice:
❏
iLO MP firmware E.02.20 or higher:
XD
Diagnostics Menu:
Non destructive tests:
P - Parameter checksum
I - I2C access (get Power Monitor Status)
L - LAN access (PING)
M - Modem selftests
Destructive tests:
R - Restart the MP
Enter menu item or [Q] to Quit:
4. Select option
5. To reset the iLO MP card, enter
confirm the reset.)
Wait for the status message to clear:
The MP is now being reset...
HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
xd
3 L
or to ping the LAN and verify the LAN settings are correctly configured.
R
and press
Y Enter
and press at the confirmation prompt.
command. The following displays, depending on the
Enter
. (If prompted, enter
System Configuration
Enter
.
Y Enter
and press to
45