Secure The System Board On Its Standoffs - HP Integrity rx2600 Operation And Maintenance Manual

Removing and Replacing Components
3. Slide the system board back toward the rear of the server to secure the system board on its
standoffs.

Secure the System Board on its Standoffs

4. Screw in the system board mounting screw.
5. Connect all cables to their appropriate connectors on the system board.
6. Screw in the six rear backplane system board mounting screws.
7. If the server does not have an iLO MP card, replace the power connectors in their slots on the
back of the server and screw in the power connector mounting screws.
8. Replace the following server components:
❏
iLO MP card
❏
Processor airflow guide
❏
System fans
❏
PCI/AGP card cage
❏
Memory
9. Replace the server covers, reconnect all of the power and external cables and power on the
server.
10. Verify that the processor works:
❏
Run the
❏
On servers with firmware version 2.0 or higher, check the configuration using the EFI
System Configuration menu
11. Review the system configuration in the EFI shell and reconfigure settings as necessary.
102
info cpu
command at the EFI shell prompt or,
HP Integrity rx2600 server and HP workstation zx6000 Operation and Maintenance Guide
.