Arp Inspection Log Status - ZyXEL Communications MES-3528 User Manual

Table 78 ARP Inspection VLAN Status
LABEL
Forwarded
Dropped

26.6.2 ARP Inspection Log Status

Use this screen to look at log messages that were generated by ARP packets and
that have not been sent to the syslog server yet. To open this screen, click
Advanced Application > IP Source Guard > ARP Inspection > Log Status.
Figure 126 ARP Inspection Log Status
The following table describes the labels in this screen.
Table 79 ARP Inspection Log Status
LABEL
Clearing log status
table
Total number of
logs
Index
Port
VID
Sender MAC
Sender IP
Num Pkts
MES-3528 User's Guide
DESCRIPTION
This field displays the total number of ARP packets the Switch
forwarded for the VLAN since the Switch last restarted.
This field displays the total number of ARP packets the Switch
discarded for the VLAN since the Switch last restarted.
DESCRIPTION
Click Apply to remove all the log messages that were generated by
ARP packets and that have not been sent to the syslog server yet.
This field displays the number of log messages that were generated
by ARP packets and that have not been sent to the syslog server yet.
If one or more log messages are dropped due to unavailable buffer,
there is an entry called overflow with the current number of
dropped log messages.
This field displays a sequential number for each log message.
This field displays the source port of the ARP packet.
This field displays the source VLAN ID of the ARP packet.
This field displays the source MAC address of the ARP packet.
This field displays the source IP address of the ARP packet.
This field displays the number of ARP packets that were consolidated
into this log message. The Switch consolidates identical log
messages generated by ARP packets in the log consolidation interval
into one log message. You can configure this interval in the ARP
Inspection Configure screen. See
Chapter 26 IP Source Guard
Section 26.7 on page 242.
241