ZyXEL Communications MES-3528 User Manual page 247

Table 82 ARP Inspection VLAN Configure (continued)
LABEL
VID
Enabled
Log
Apply
Cancel
MES-3528 User's Guide
DESCRIPTION
This field displays the VLAN ID of each VLAN in the range specified
above. If you configure the * VLAN, the settings are applied to all
VLANs.
Select Yes to enable ARP inspection on the VLAN. Select No to disable
ARP inspection on the VLAN.
Specify when the Switch generates log messages for receiving ARP
packets from the VLAN.
None: The Switch does not generate any log messages when it
receives an ARP packet from the VLAN.
Deny: The Switch generates log messages when it discards an ARP
packet from the VLAN.
Permit: The Switch generates log messages when it forwards an ARP
packet from the VLAN.
All: The Switch generates log messages every time it receives an ARP
packet from the VLAN.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click this to reset the values in this screen to their last-saved values.
Chapter 26 IP Source Guard
247