Configuring Snmp Trap Group - ZyXEL Communications MES-3528 User Manual

Chapter 33 Access Control
Table 102 Management > Access Control > SNMP (continued)
LABEL
Privacy
Apply
Cancel

33.3.5 Configuring SNMP Trap Group

Click Management > Access Control > SNMP > Trap Group to view the screen
as shown. Use the Trap Group screen to specify the types of SNMP traps that
should be sent to each SNMP manager.
Figure 160 Management > Access Control > SNMP > Trap Group
294
DESCRIPTION
Specify the encryption method for SNMP communication from this user.
You can choose one of the following:
• DES - Data Encryption Standard is a widely used (but breakable)
method of data encryption. It applies a 56-bit key to each 64-bit
block of data.
• AES - Advanced Encryption Standard is another method for data
encryption that also uses a secret key. AES applies a 128-bit key to
128-bit blocks of data.
Click Apply to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
MES-3528 User's Guide