Supported Radius Attributes - ZyXEL Communications MES-3528 User Manual

Table 66 Supported VSAs
FUNCTION
Egress Bandwidth
Assignment
Privilege
Assignment
25.2.4.1 Tunnel Protocol Attribute
You can configure tunnel protocol attributes on the RADIUS server (refer to your
RADIUS server documentation) to assign a port on the Switch to a VLAN based on
IEEE 802.1x authentication. The port VLAN settings are fixed and untagged. This
will also set the port's VID. The following table describes the values you need to
configure. Note that the bolded values in the table are fixed values as defined in
RFC 3580.
Table 67 Supported Tunnel Protocol Attribute
FUNCTION
VLAN Assignment

25.3 Supported RADIUS Attributes

Remote Authentication Dial-In User Service (RADIUS) attributes are data used to
define specific authentication, and accounting elements in a user profile, which is
stored on the RADIUS server. This appendix lists the RADIUS attributes supported
by the Switch.
MES-3528 User's Guide
ATTRIBUTE
Vendor-Id = 890
Vendor-Type = 2
Vendor-data = egress rate (Kbps in decimal format)
Vendor-ID = 890
Vendor-Type = 3
Vendor-Data = "shell:priv-lvl=N"
or
(CISCO)
Vendor-ID = 9
Vendor-Type = 1 (CISCO-AVPAIR)
Vendor-Data = "shell:priv-lvl=N"
where is a privilege level (from 0 to 14).
N
Note: If you set the privilege level of a login account differently
on the RADIUS server(s) and the Switch, the user is
assigned a privilege level from the database (RADIUS or
local) the Switch uses first for user authentication.
ATTRIBUTE
Tunnel-Type = VLAN(13)
Tunnel-Medium-Type = 802(6)
Tunnel-Private-Group-ID =
Note: You must also create a VLAN with the specified VID on
the Switch.
Chapter 25 AAA
VLAN ID
219