ZyXEL Communications MES-3528 User Manual page 204

Chapter 24 Multicast
The following table describes the related labels in this screen.
Table 60 Advanced Application > Multicast > Multicast Setting > MVR
LABEL
Active
Name
Multicast VLAN
ID
802.1p Priority
Mode
Port
*
Source Port
Receiver Port
None
Tagging
Add
Cancel
VLAN
Active
Name
Mode
Source Port
Receiver Port
802.1p
204
DESCRIPTION
Select this check box to enable MVR to allow one single multicast VLAN
to be shared among different subscriber VLANs on the network.
Enter a descriptive name (up to 32 printable ASCII characters) for
identification purposes.
Enter the VLAN ID (1 to 4094) of the multicast VLAN.
Select a priority level (0-7) with which the Switch replaces the priority in
outgoing IGMP control packets (belonging to this multicast VLAN).
Specify the MVR mode on the Switch. Choices are Dynamic and
Compatible.
Select Dynamic to send IGMP reports to all MVR source ports in the
multicast VLAN.
Select Compatible to set the Switch not to send IGMP reports.
This field displays the port number on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all
ports. Use this row first to set the common settings and then make
adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select this option to set this port as the MVR source port that sends and
receives multicast traffic. All source ports must belong to a single
multicast VLAN.
Select this option to set this port as a receiver port that only receives
multicast traffic.
Select this option to set the port not to participate in MVR. No MVR
multicast traffic is sent or received on this port.
Select this checkbox if you want the port to tag the VLAN ID in all
outgoing frames transmitted.
Click Add to save your changes to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
This field displays the multicast VLAN ID.
This field displays whether the multicast group is enabled or not.
This field displays the descriptive name for this setting.
This field displays the MVR mode.
This field displays the source port number(s).
This field displays the receiver port number(s).
This field displays the priority level.
MES-3528 User's Guide