ZyXEL Communications MES-3528 User Manual page 200

Chapter 24 Multicast
Click Advanced Applications > Multicast > Multicast Setting > IGMP
Filtering Profile link to display the screen as shown.
Figure 102 Advanced Application > Multicast > Multicast Setting > IGMP Filtering
Profile
The following table describes the labels in this screen.
Table 59 Advanced Application > Multicast > Multicast Setting > IGMP Filtering
Profile
LABEL
Profile Name
Start Address
End Address
Add
Clear
Profile Name
Start Address
End Address
200
DESCRIPTION
Enter a descriptive name for the profile for identification purposes.
To configure additional rule(s) for a profile that you have already added,
enter the profile name and specify a different IP multicast address
range.
Type the starting multicast IP address for a range of multicast IP
addresses that you want to belong to the IGMP filter profile.
Type the ending multicast IP address for a range of IP addresses that
you want to belong to the IGMP filter profile.
If you want to add a single multicast IP address, enter it in both the
Start Address and End Address fields.
Click Add to save the profile to the Switch's run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
This field displays the descriptive name of the profile.
This field displays the start of the multicast address range.
This field displays the end of the multicast address range.
MES-3528 User's Guide