Auxiliary Dc Jack; Shroud Latches - Yamaha PZ50FXW Owner's Manual

ESU04301

Auxiliary DC jack

For PZ50VT
The auxiliary DC jack is located in the front panel and
can be used for accessories.
NOTE:
@
The auxiliary DC jack cannot be used if the engine is not
running.
@
1. Start the engine.
2. Open the auxiliary DC jack cap 1, and then insert
the accessory power plug into the jack 2.
NOTE:
@
After using the auxiliary DC jack, be sure to remove the
accessory power plug from the jack and close the auxil-
iary DC jack cap.
@
CAUTION :
@
G
Do not use accessories requiring more than the
maximum rated capacity for the auxiliary DC jack.
This may overload the circuit and cause the fuse
to blow. (See page 8-33 for the specified amper-
age.)
G
Do not use an automotive cigarette lighter or
other accessory with a plug that gets hot
because the jack can be damaged.
@
Maximum rated capacity: DC 12 V, 2.5 A (30 W)
ESU00482

Shroud latches

For PZ50VT
To open the shroud, unhook the shroud latches, and then
slowly raise the shroud forward until it stops. When clos-
ing the shroud, slowly lower it to its home position, and
then hook the shroud latches.
1 Shroud latch
2 Shroud
5-12