Yamaha PZ50FXW Owner's Manual page 63

Right upper cover (for PZ50FX/PZ50GT/PZ50M)
To remove the right upper cover
1. Remove the top cover. (See the above procedure.)
2. Remove the right upper cover by removing the bolts.
1 Right upper cover bolt
2 Right upper cover
To install the right upper cover
1. Place the right upper cover in the original position,
and then install and tighten the bolts to the specified
torque.
Right upper cover bolt tightening torque:
8 Nm (0.8 m·kgf, 6 ft·lb)
2. Install the top cover.
Left and right upper covers (for PZ50VT)
To remove an upper cover
1. Open the shroud. (See the above procedure.)
2. Loosen the quick fasteners, and then remove the
upper cover.
1 Quick fastener
2 Left upper cover
3 Right upper cover
To install an upper cover
Insert the projections on the upper cover into the slots
and fit the holders on the cover onto the grommets, and
then tighten the quick fasteners.
4 Projection
5 Holder
6 Grommet
7 Slot
WARNING
@
G Do not drive the snowmobile with the shroud or
covers unfastened or removed.
G
Keep your body and clothing away from rotating
parts when servicing the snowmobile with the
shroud open or the covers removed.
G Do not touch the hot muffler and engine during or
immediately after operation.
@
8-8