Table of Contents
Advertisement
1. Thumb warmer adjusting switch
To raise the temperature
To raise the temperature, press the respec-
tive switch to "HI".
To lower the temperature
To lower the temperature, press the respec-
tive switch to "LO".
See "Fuel meter and grip/thumb warmer level
indicator" on page 15 for detailed informa-
tion.
ESU10697
Auxiliary DC jack
The auxiliary DC jack is located in the front
panel and can be used for accessories.
TIP
The auxiliary DC jack can only be used if the
engine is running.
To use the auxiliary DC jack
1.
Start the engine.
2.
Open the auxiliary DC jack cap, and then
insert the accessory power plug into the
jack.
Control functions
1. Auxiliary DC jack cap
2. Auxiliary DC jack
3.
After using the auxiliary DC jack, be sure
to remove the accessory power plug
from the jack and to close the auxiliary
DC jack cap.
ECS00123
NOTICE
To avoid circuit overload and a possible
fuse blowing, do not use accessories re-
quiring more than the maximum rated
capacity for the auxiliary DC jack. (See
page 71 for the specified fuse amper-
age.)
Do not use an automotive cigarette
lighter or other accessory with a plug
that gets hot because the jack can be
damaged.
Maximum rated capacity:
DC 12 V, 2.5 A (30 W)
ESU13265
Helmet shield heater jack
The helmet shield heater jack is located on
the left side of the handlebar.
TIP
The helmet shield heater jack can only be
used if the engine is running.
To use the helmet shield heater jack
1.
Start the engine.
1
2
19
Hide quick links:
Advertisement
Table of Contents
