Grip/Thumb Warmer Adjustment Switch; Auxiliary Dc Jack - Yamaha RS Venture RST90Y Owner's Manual

Control functions
1. Headlight beam switch "LIGHTS"
2. High beam "HI"
3. Low beam "LO"
ESU12651
Grip/thumb warmer adjustment
switch
The grip warmer adjustment switch and the
thumb warmer adjustment switch control the
electrically heated handlebar grips and throt-
tle lever respectively.
1. Grip warmer adjustment switch
1. Thumb warmer adjustment switch
14
To raise the temperature, press the respec-
tive switch to "HI". To lower the temperature,
press the switch to "LO". (See page 10 for
more information.)
ESU10691

Auxiliary DC jack

The auxiliary DC jack is located in the front
panel and can be used for accessories.
TIP
The auxiliary DC jack cannot be used if the
engine is not running.
To use the auxiliary DC jack
1. Start the engine.
2. Open the auxiliary DC jack cap, and then
insert the accessory power plug into the
jack.
1. Auxiliary DC jack cap
2. Auxiliary DC jack
3. After using the auxiliary DC jack, be sure
to remove the accessory power plug from
the jack and to close the auxiliary DC jack
cap.
ECS00120
NOTICE
Do not use accessories requiring more
G
than the maximum rated capacity for the
auxiliary DC jack. This may overload the
circuit and cause the fuse to blow. (See
page 63 for the specified amperage.)