Yamaha PZ50FXW Owner's Manual page 82

WARNING
@
This shock absorber contains highly pressurized
nitrogen gas. It could explode by improper handling,
causing injury, or property damage.
G Do not tamper with or attempt to open the shock
absorber.
G
Do not subject the shock absorber to an open
flame or other high heat source, which could
cause it to explode.
G Do not deform or damage the shock absorber in
any way.
G Do not dispose of a worn or damaged shock
absorber by yourself. Take the unit to a Yamaha
dealer.
@
ESU04221
Adjusting the control rods
For PZ50VT
The weight transfer can be adjusted by turning the con-
trol rod adjusting nut 1.
1. Loosen the locknut 2 while holding the control rod
adjusting nut.
2. Turn the adjusting nut in direction a to increase
weight transfer or direction b to decrease weight
transfer.
3. Tighten the locknut while holding the adjusting nut in
place.
Locknut tightening torque:
25 Nm (2.5 m·kgf, 18 ft·lb)
CAUTION :
@
G
When using the two wrenches included in the
owner's tool kit, make sure that they are situated
at a right angle to the control rod as shown, and
that they are tightly fitted to the locknut and the
control rod adjusting nut.
G The left and right adjusting nuts must be set to
the same position. Uneven settings can cause
poor handling and loss of stability.
@
8-27