Camera - Panasonic WJ-SX550A Operating Instructions Manual

Note: The desired monitor selection may not be avail-
able due to one of the following reasons:
1. The System Controller used for selecting a partic-
ular monitor is not allowed access to that monitor
because of keyboard partitioning. See page 20
for more details.
2. The desired monitor is presently selected by
another operator who has a higher operator priori-
ty, and therefore, control over that monitor. At this
time "Monitor Busy" or "NOT AVAILABLE" will be
displayed on the System Controller's LCD panel.
2-2. Camera Selection
2
The video signal from the desired camera can be supplied
to the selected monitor by using the System Controller.
Press the Numeric keys (1 to 128) then press the CAM key
to select the desired camera.
For example: When selecting Camera No.2:
Press 2 then press CAM key
Note: The desired camera selection may not be avail-
able due to one of the following reasons:
1. The operator is not allowed access to the desired
camera because the Operator Registration has
limited the operator's access to certain cameras.
See page 19 for more details.
2. The desired camera is currently selected by
another operator who has a higher operator priori-
ty, and therefore, control over that camera. At this
time "Camera Busy" will be displayed on the
System Controller's LCD panel.
3. Camera Control
The selected camera (and, if applicable, the receiver) can
be controlled by the System Controller.
Specified Panasonic cameras, such as the WV-BP510, or
the WV-CP610 series, can have various functions con-
trolled remotely without the need for a receiver.
Note: Because future camera models may have additional
features and functions, please refer to the Operating
Instructions Manual provided with the camera for more
details.
1 2 3
4 5 6
7 8 9
0
MON CAM
ESC SET
4. Accessory Control
4-1. Iris Control
This control is used to open or close the iris of specified
DC servo lens with Panasonic WV-BP510, or WV-CP610
series cameras.
ALARM BUSY
F1
ACK BACK FORWARD
1 2
RESET SEQ SEQ ALT
4 5
7 8
AUX DEC INC
1 2 -1CAM +1CAM STOP
0
MON
ESC
4-2. Pan/Tilt Control
This control is used to pan or tilt the pan/tilt head.
The following operations are available.
1. Manual Operation
Press the Joystick Controller to move the Pan/Tilt head
towards the desired direction. Eight directions are
available: UP / DOWN / RIGHT/LEFT / UP-RIGHT / UP-
LEFT / DOWN-RIGHT / DOWN-LEFT.
2. Auto Panning Operation
It is necessary to use a Pan/Tilt head such as the WV-
7225.
3. Random Panning Operation
It is also necessary to use a Pan/Tilt head which has
the auto panning capability such as the WV-7225.
4-3. Auxiliary (AUX) Control
This control is used to turn on or off the user's auxiliary
switches located in the Receiver, such as the WV-RC100,
WV-RC150 or WV-RC170 Receivers.
-14-
F2 F3 F4
UP
IRIS
3
PRESET CLOSE OPEN
CLOSE OPEN
LEFT RIGHT
6
AF
9
ZOOM FOCUS
DOWN
TELE NEAR
CAM
WIDE FAR
SET
550
A
System Controller WV-CU
IRIS