Panasonic WJ-SX550A Operating Instructions Manual page 119

15. Camera Position Number Setting
The following function is available only when the Mode
Selection Switch is selected at CAM-P Mode on the rear of
the System Controller.
Refer to the Mode Selection on page 56.
15-1 Register Camera Position Number
1. Select the desired monitor.
Refer to the Monitor Selection on page 98.
2. Select the CAM-P (D5) Menu as shown below on the
LCD by pressing the appropriate Cursor Keys.
D5
CAM-P Menu
Set Clear Test Mode
F1 F2
3. Press the Function (F1) Key to display shown below
on the LCD.
Enter the camera number by pressing the Numeric
keys, then press the Set (SET) Key.
C
C 01 Pre
4. Enter the preset position number by pressing the
Numeric Keys, then press the Set (SET) Key. The
selected camera preset position picture appears on
the monitor and displays on the LCD as shown below.
C 01 Pre64 CAM-P
Input OK?-->Set/Esc
F3 F4
Exit
Exit
5. Enter the Camera Position Number by pressing the
Numeric Keys.
When completed above steps, press the Set (SET)
Key to execute the selection.
If made mistake on the above steps, press the Escape
(ESC) Key to cancel the selection.
C
F1 F2
Note: Up to 1,000 positions are registered in this
menu. "Data Full" display will be appeared on the
LCD by registering over 1,000 positions.
6. Repeat the above steps for other camera positions.
When satisfied with all positions, press the Function
(F4) Key to exit from the programming mode.
15-2 Delete Camera Position Number
1. Select the desired monitor.
Refer to the Monitor Selection on page 98.
2. Select the CAM-P (D5) Menu as shown below on the
LCD by pressing the appropriate Cursor Keys.
D5
CAM-P Menu
Set Clear Test Mode
F1 F2
3. Press the Function (F2) Key to display shown below
on the LCD.
F1 F2
4. Enter the camera position number for deleting by
pressing the Numeric keys, then press the Set (SET)
Key. The selected camera position picture appears on
the monitor and displays on the LCD shown below.
C 01 Pre64 CAM-P9999
Input OK?-->Set/Esc
F1 F2
-115-
Exit
F3 F4
F3 F4
CAM-P
Exit
F3 F4
F3 F4
6