Panasonic WJ-SX550A Operating Instructions Manual page 125

Symptom: While running the Preset Test, the WV-CS500 Combination Camera stops at preset positions for extended
periods of time.
1. If the WV-CS500 had it's preset positions originally programmed by other systems, there are dwell times associated
with those positions that will determine how long the Preset Test will take.
Re-programme the presets by using the Matrix Switcher to eliminate the dwell times.
Symptom: The Timer Event mode will not activate.
1. The Timer Event is defined in this system as Operator 00. Initially, the priority of operator 00 is set to 30 at the factory
(the lowest priority). If another operator with a higher priority is currently operating the desired devices, the Timer
Event will not occur (however, a backslash symbol "/" with either a Tour or Group Sequence number will appear in
the upper-right corner of the monitor screen, for example: /T02). Increase the priority of operator 00 through use of
the Operator Registration Table to enable the Timer Event.
2. If a Special Day Schedule is programmed, make sure that the month, day, and year are all filled out.
3. The order of priority for days of the week and special days is: Special Day has a higher priority than a regular day.
Also, a Special Day entered in the Special Day Schedule Table before another Special Day is entered has a higher
priority.
Symptom: The printer will not stop printing even though the Escape (ESC) Key is pressed.
1. The characters that are already sent to the buffer in the printer will be printed out, regardless of the ESC Key being
pressed. This is normal.
Symptom: PROHIBIT appears in the LCD display.
1. The function attempted is not allowed because of the operator's level or there is operator's lockout of camera video
and/or Pan/Tilt Control. Press the ESC Key to clear display. Change the operator's level and/or video lockout setup.
Symptom: WARNING! PROHIBITED! appears on the monitor screen.
1. The System Controller is not allowed to access a particular monitor due to Keyboard/Monitor partitioning. Change
Keyboard/Monitor partitioning in the Set Up Menu.
Symptom: When Log-in is attempted, "No Entry" appears on the LCD.
1. An incorrect password or operator number is used during log-in. Use the correct password and operator number.
Symptom: When Log-in is attempted, "Monitor Busy" appears on the LCD.
1. All monitors are currently being used by an operator or event with a higher priority than this operator. Either change
the priority of the operator to an equal or higher priority or wait for the current operator or event to complete their use
of the monitors.
Symptom: "Monitor (#) Busy" appears in the LCD and the Busy LED also lights.
1. Another operator with greater priority is using that monitor. Wait until higher priority operator releases the monitor.
2. Another operator with equal priority has taken control over that monitor. Re-take control from that operator.
Symptom: "Camera (#) Busy" appears in the LCD and the Busy LED also lights.
1. Another operator with greater priority is using that camera. Wait until higher priority operator releases the camera.
2. Another operator with equal priority has taken control over that camera. Re-take control from that operator.
Symptom: The Busy LED lights up.
All monitors are busy. Wait until event or operator releases control over all monitors.
Symptom: "NOT AVAILABLE" appears in the LCD.
1. A Priority Lock is in effect for that monitor. Select another monitor.
Symptom: The Alarm LED lights up.
1. An alarm has been received. To clear the alarm, first select the alarmed monitor, acknowledge the alarm with the
ACK RESET Switch. Then, clear the alarm by again pressing the ACK RESET Switch or wait until the Auto Reset
function clears the alarm after a predetermined amount of time has past.
-121-
7