Panasonic WJ-SX550A Operating Instructions Manual page 37

WV-PB5504AE Video Output Board Dip Switch Setting
1. Set switches (SW1) on the board to meet the monitor output number as shown in the following table.
Initially, monitor 1 - 4 is selected at the factory.
BOARD MONITOR
SW1 SETTING
NO. OUT NO.
1
1 1-4
OFF
1
2 5-8
OFF
1
3 9-12
OFF
1
4 13-16
OFF
1
5 1-4
OFF
1
6 5-8
OFF
1
7 9-12
OFF
1
8 13-16
OFF
2. Set switches (SW2/SW3/SW4/SW5) on the board to choose the alarm reset output signal as
either Open Collector (OPEN C.) or Pulse (VTR).
Open Collector (OPEN C.): 16VDC 100mA max.
Pulse (VTR): +5VDC approx. 500 msec.
Initially, VTR positions are selected at the factory.
Be careful when setting these switches as the switches are not physically located on the
board in numerical order. Switch location from the top of the board, going downward, is: SW4
(reset out 3), SW5 (reset out 4), SW3 (reset out 2) and SW2 (reset out 1).
3. Set switches (SW100/SW150/SW200/SW250) on the board to choose the
character display mode on the monitor.
NOR: White with Black border
REV: Black with White border
Initially, normal (NOR) positions are selected at the factory.
MONITOR OUT NO.
BOARD
NO.
SW100 SW150 SW200 SW250
1 (5) 1 2
2 (6) 5 6
3 (7) 9 10
4 (8) 13 14
4. Confirm switches (SW6) on the board are set to the following positions.
These switches are used only for factory test.
Always keep these switches in the positions shown on right in the field.
2 3 4
2 3 4
2 3 4
2 3 4
2 3 4
2 3 4
2 3 4
Caution
• The Board Number 5 to 8 are only used when the WJ-AD550
Extension Unit is used.
2 3 4
• The Board Number 1 to 4 should be installed in the WJ-SX550A
Matrix Switcher and the Board Number 5 to 8 are installed in the WJ-
AD550 Extension Unit. Do not install more than five (5) boards in the
WJ-SX550A Matrix Switcher.
Note
3 4
7 8
11 12
15 16
Note
-33-
1 2
SW4
SW6
SW5
OFF
SW3
SW2
SW100
SW150
SW200
SW250
NOR REV
NOR Position
PAL
SW6
NTSC
CH1
OPEN C
VTR
NOR REV
REV Position
1 2 TEST
NOR
OFF
3