Panasonic WJ-SX550A Operating Instructions Manual page 120

5. Confirm the display on the LCD, then press the Set
(SET) Key to delete the selected Camera Position
Number.
If made mistake on the above steps, press the Escape
(ESC) Key to cancel the selection.
6. Repeat the above steps for other camera position
numbers.
When satisfied with all positions, press the Function
(F4) Key to exit from the programming mode.
F1 F2
15-3 Camera Position Test Mode
1. Select the desired monitor.
Refer to the Monitor Selection on page 98.
2. Select the CAM-P (D5) Menu as shown below on the
LCD by pressing the appropriate Cursor Keys.
D5
CAM-P Menu
Set Clear Test Mode
F1 F2
3. Press the Function (F3) Key to display shown below
on the LCD.
6
Test1 CAM-P----
F1 F2
4. Press the Function (F1) Key to activate the test mode,
the selected camera position picture appears on the
monitor at intervals of 3 seconds, starting from the
lowest camera position number to the highest camera
position number.
Press the Function (F1) Key repeatedly to select the
mode On or Off as shown below.
CAM-P
Exit
F3 F4
F3 F4
Act Exit
F3 F4
: On
: Off
5. The above function will automatically stop and dis-
plays on the LCD shown below
Press the Function (F4) Key to return to the previous
Camera Position Menu.
Test1 CAM-P9999 End
-Act
F1 F2
15-4 Camera Position Mode Selection
It is available only the camera position number operation
when the camera position mode is selected at On mode.
1. Select the CAM-P (D5) Menu shown below on the LCD
by pressing the appropriate Cursor Keys.
D5
CAM-P Menu
Set Clear Test Mode
F1 F2
3. Press the Function (F4) Key to display shown below
on the LCD.
CAM-P Mode Off
On
F1 F2
Press the Function (F1) Key repeatedly to select the
mode On or Off.
4. Press the Function (F4) Key to return to the previous
CAM-P Menu.
Note:The Monitor (MON) Key will be activated as the
Camera Position Set Key when the CAM-P Mode
is selected at On mode.
If selecting the monitor, enter the desired number
by pressing the Numeric Keys then press the
Function (F1) Key instead of the Monitor (MON)
Key, while the Monitor Selection (A1) Menu is dis-
played.
-116-
Exit
F3 F4
F3 F4
Exit
F3 F4