Panasonic WJ-SX550A Operating Instructions Manual page 40

17. Auxiliary Switches (AUX 1,2)
These switches are used to control the auxiliary
switches inside the Receiver (WV-RC100, WV-RC150
or WV-RC170 ).
For example, these auxiliary switches can be used for
turning on and off a light, a buzzer, etc.
18. Alternate Switch (ALT)
This switch, in combination with the other switch, is
used to activate the special functions.
19. Forward Sequence Switch (FORWARD SEQ)
This switch, is combination with the Numeric Keys, is
used to start a program or tour sequence on a moni-
tor, or to continue a sequence, in the forward direc-
tion, that was previously stopped on a monitor by the
Stop (STOP) switch.
3
20. Backward Sequence Switch (BACK SEQ)
This switch is used to continue a sequence, in the
backward direction, that was previously stopped on a
monitor by the Stop (STOP) Switch.
21. Alarm Acknowledge and Reset Switch
(ACK RESET)
This switch is used to cancel an active alarm. To can-
cel an alarm, the alarmed monitor (s) must first be
selected, then this switch must be pressed once for
alarm acknowledgement (the light blinks rapidly),
then this switch must be pressed once again for alarm
reset.
After alarm acknowledgement, press the Alternate
(ALT) Switch then press this switch to reset the all acti-
vated alarms at once.
22. Data Input/Output Connectors (DATA IN, OUT)
These connectors are used to transmit/receive control
data to/from the WJ-SX550A Matrix Switcher in a sys-
tem.
23. Termination Switch (TERM ON/OFF)
This switch is used to enable termination of this con-
troller's data connector.
24. Controller Unit Number Switch (CONTROLLER
UNIT NO.)
This switch is used to identify the unit number of the
System Controller in multiple system controller appli-
cations. Up to eight controllers can be installed in a
system.
25. Mode Selection Switch (MODE)
These switches are used to select the mode of the
System Controller connected to the Matrix Switcher
Select the switches as shown below.
Normal Mode
CAM-P Mode
26. Controller On/Off Switch (CONTROLLER ON/OFF)
This switch is used to turn power on and off to the
System Controller.
27. Power Cord
-36-
MODE
OFF
ON
MODE
OFF
ON