Panasonic WJ-SX550A Operating Instructions Manual page 39

1. Alarm Indicator (ALARM)
This LED indicator blinks to indicate an alarm
tion exists.
2. Busy Indicator (BUSY)
This LED indicator lights up when one or more System
Controllers with a higher operator priority than this one
are used to perform a function with the same camera
or monitor at the same time.
While this indicator is lighted, operations from this
System Controller are deactivated and can not be
performed until the indicator goes off.
3. Function Keys (F1/F2/F3/F4)
These keys are used to select functions displayed on
the Liquid Crystal Display.
4. Liquid Crystal Display
This displays function menus and function status.
In this Instructions Manual it is hereafter referred to
as the "LCD".
(A, C, D, B)
5. Cursor Keys
These keys are used to select which function menus
are displayed on the LCD.
6. Joystick Controller (UP/DOWN/LEFT/RIGHT)
This Joystick is used to operate the Pan/Tilt Head
manually, or to move the cursor to the desired position
on the Set Up Menu of the Matrix Switcher.
7. Lens Iris Switches (IRIS CLOSE, OPEN)
These switches are used to close or open the lens iris
of specified lenses mounted on the camera.
When these switches are pressed at the same time for
3 seconds, the lens iris is set to the factory preset con-
dition.
8. Focus Control (FOCUS NEAR/FAR)
This control is used to adjust lens focus of specified
lenses mounted on the camera.
9. Zoom Control (ZOOM TELE/WIDE)
This control is used to adjust lens zoom of specified
lenses mounted on the camera.
10. Preset Switch (PRESET)
Auto Focus Switch (AF)
PRESET: This switch, in combination with the
Numeric Keys, is used to activate the preset func-
tion of the WV-CS500 or WV-CS600 Combination
Camera.
AF: This switch is used to activate the auto focus
condi- function when selected the specified camera
such as the WV-CS600 Combination Camera.
11. Camera Key (CAM)
Set Key (SET)
CAM : This key is used for camera selection. Press
SET : This key is used to execute the currently high-
12. Numeric Keys ( 0 - 9 )
These keys are used for numeric input into the system
such as camera and monitor select, sequence, etc.
13. Monitor Key (MON)
Escape Key (ESC)
MON : This key is used for monitor selection. Press
ESC : This key is used to escape the currently high-
Press this key, after pressed the Alternate (ALT)
Switch, to display the video systematically, which is
connected to the Monitor Input (MONITOR IN)
Connector on the WV-PB5504AE Video Output Board.
14. Stop Switch (STOP)
This switch is used to stop a sequence that is being
run on a monitor.
15. Increment Switch (INC +1 CAM)
This switch is used to move a sequence one step for-
ward from the step that was previously stopped on the
monitor by the Stop (STOP) Switch.
Also, when a selected monitor is in the spot mode,
pressing this switch will replace the presently selected
camera with the next higher camera number.
16. Decrement Switch (DEC - 1 CAM)
This switch is used to move a sequence one step
backward from the step that was previously stopped
on the monitor by the Stop (STOP) Switch.
Also, when a selected monitor is in the spot mode,
pressing this switch will replace the presently selected
camera with the next lower camera number.
-35-
the desired Numeric Keys then press this key
to select the camera.
lighted setting on the Set Up Menu of the
Matrix Switcher.
the desired Numeric Keys then press this key
to select the monitor.
lighted setting on the Set Up Menu of the
Matrix Switcher.
3