Panasonic WJ-SX550A Operating Instructions Manual page 114

3. Press the Function (F1) Key to select the Auto BLC
Mode.
BLC Off
Auto Preset
F1 F2
BLC Auto
Off
F1 F2
Press the Function (F1) Key to turn off the Auto BLC
Mode or press the Function (F2) Key to select the
Preset BLC Mode.
4. Press the Function (F2) Key to select the Preset BLC
Mode.
BLC Off
Auto Preset
F1 F2
BLC Preset
Auto Off
F1 F2
6
Press the Function (F2) Key to turn off the Preset BLC
Mode or press the Function (F1) Key to select the
Auto BLC Mode.
10-6 Camera Set Up
The following functions are only available with cameras
that have set up functions such as the Panasonic WV-
CP610 or WV-BP510 series, WV-CS600 or WV-CS400 cam-
eras.
1. Select the desired camera and monitor.
Refer to the Camera Selection and Monitor Selection
on page 98.
2. Select the Camera Set up (D4) Menu on the LCD by
pressing the appropriate Cursor Keys.
D4
Camera Set Up Menu
On
F1
F3 F4
Preset
F3 F4
F3 F4
F3 F4
Exit
F2 F3 F4
Note: The default setting is set up on. Pressing the
Function (F1) Key at this point will allow access to
the Camera Set up menu if such access is autho-
rized by the operator's level.
appears on the LCD, press the Escape (ESC)
Key to return the Camera Set up menu display.
3. Press the Function (F1) Key to gain access to the
Camera Set Up Menu.
The menu now appears on the selected monitor.
For example, the WV-CP610 series cameras are dis-
played as shown below.
Camera Set Up Menu
F1 F2
** SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SENSE UP
SYNC
WHITE BAL
WIDE D-RANGE OFF
MOTION DET
DNR
END
4. Select the desired item by moving the Joystick
Controller UP and DOWN and then select the desired
mode by moving the Joystick Controller LEFT and
RIGHT.
Press the Set (SET) Key to execute the setting or
entering sub menu, and press the Escape (ESC) Key
to escape from the setup mode or menu.
5. Press the Function (F2) Key to reset the selected
menu and press the Function (F3) Key to reset all set-
tings to initial state.
Refer to the Operating Instructions of the selected cam-
era for more details.
6. Press the Function (F4) Key to return to the original
screen.
Caution: If camera setup is started with switches on the
back of the camera, all settings must be made with
the switches on the camera's rear panel.
If camera setup is started with a Matrix Switcher, all
settings must be made with the Matrix Switcher. Then,
exit.
-110-
If PROHIBITED
Res A.Res Exit
F3 F4
OFF
ALC
OFF
ON
OFF
INT
ATW
OFF
OFF
SET UP ENABLE
Note