Panasonic WJ-SX550A Operating Instructions Manual page 103

6. Controlling System Accessories
Controls for system accessories are located on the right
side of the front panel of the System Controller.
Included are Zoom Control, Focus Control, Iris Control,
Preset and Pan/Tilt Controls. Normally, a WV-RC100, WV-
RC150 or WV-RC170 Receiver is required to perform these
functions.
6-1 Lens Control
Confirm that the correctly specified lens, which has
motorized zoom/focus functions, is mounted on the
camera. Also confirm that the Lens Selection Switch
(DC/VIDEO) on the camera is set to the DC position.
1. Select the desired camera and monitor.
Refer to the Camera Selection and Monitor Selection
on page 98.
2. Press the Focus (FOCUS NEAR/FAR) Control to
adjust the lens focus to achieve a sharply focused pic-
ture while observing the monitor.
FOCUS
NEAR
FAR
Press the Auto Focus (AF) Switch to adjust the lens
focus automatically, when specified camera with the
auto focus feature, such as the Panasonic WV-CS600,
is used.
PRESET
AF
3. Press the Zoom (ZOOM TELE/WIDE) Control to adjust
the lens zoom to achieve the desired picture while
observing the monitor.
Press this control to the TELE position to optically
bring an object closer. Pressing to the WIDE position
has the reverse effect.
4. Press the Lens Iris (IRIS CLOSE, OPEN) Switches to
close/open the lens iris. Adjust the lens iris by using
the switches to obtain the proper picture exposure.
By pressing both of these switches at the same time
for three seconds, the lens iris is set to the factory pre-
set condition.
Note: When a camera, with an ALC Lens, has AGC
turned on, the iris close, open function will oper-
ate move slowly. By pressing the above switches
repeatedly (instead of holding down) this function
will operate faster.
5. If Lens Control is needed fine adjustment, follow the
procedures shown below.
1) Select the desired camera and monitor.
2) Select the P/T Z/F Iris (B3) Menu on the LCD by
pressing the Cursor Keys.
B3
P/T Z/F Iris
Step
F1
3) Press the Focus, Zoom or Iris Switch, while press-
ing the Function (F1) Key, to adjust fine.
Note: Press the Focus, Zoom or Iris Switch, while
pressing the Stop (STOP) Switch, to adjust fine
without displaying the P/T Z/F Iris Menu.
6-2 Pan/Tilt Control (Manual Operation)
1. Select the desired camera and monitor.
Refer to the Camera Selection and Monitor Selection
on page 98.
2. Press the Joystick Controller to move the Pan/Tilt
Head towards the desired direction.
If the joystick is positioned in between UP and RIGHT,
the Pan/Tilt Head moves diagonally towards Up and
Right.
Eight directions are available: UP/DOWN/RIGHT/LEFT/
UP-RIGHT/UP-LEFT/DOWN-RIGHT/DOWN-LEFT.
LEFT
3. If Pan/Tilt Control is needed fine adjustment, press the
Joystick Controller while pressing the Stop (STOP)
Switch, to adjust fine.
-99-
IRIS
CLOSE OPEN
UP
RIGHT
DOWN
6